The ESXi Image Profile and vSphere Installation Bundle (VIB) acceptance level must be verified.
Overview
| Finding ID | Version | Rule ID | IA Controls | Severity |
| V-258746 | ESXI-80-000133 | SV-258746r933299_rule | CCI-001749 | high |
| Description | ||||
| Verify the ESXi Image Profile to only allow signed VIBs. An unsigned VIB represents untested code installed on an ESXi host. The ESXi Image profile supports four acceptance levels: 1. VMwareCertified - VIBs created, tested, and signed by VMware. 2. VMwareAccepted - VIBs created by a VMware partner but tested and signed by VMware. 3. PartnerSupported - VIBs created, tested, and signed by a certified VMware partner. 4. CommunitySupported - VIBs that have not been tested by VMware or a VMware partner. Community Supported VIBs are not supported and do not have a digital signature. To protect the security and integrity of ESXi hosts, do not allow unsigned (CommunitySupported) VIBs to be installed on hosts. Satisfies: SRG-OS-000366-VMM-001430, SRG-OS-000370-VMM-001460 | ||||
| STIG | Date | |||
| VMware vSphere 8.0 ESXi Security Technical Implementation Guide | 2023-10-11 | |||
Details
Check Text (C-258746r933299_chk)
From the vSphere Client, go to Hosts and Clusters.
Select the ESXi Host >> Configure >> System >> Security Profile.
Under "Host Image Profile Acceptance Level" view the acceptance level.
or
From a PowerCLI command prompt while connected to the ESXi host, run the following commands:
$esxcli = Get-EsxCli -v2
$esxcli.software.acceptance.get.Invoke()
If the acceptance level is "CommunitySupported", this is a finding.
Fix Text (F-62395r933298_fix)
From the vSphere Client, go to Hosts and Clusters.
Select the ESXi Host >> Configure >> System >> Security Profile.
Under "Host Image Profile Acceptance Level", click "Edit".
Using the drop-down selection, set the acceptance level as "VMwareCertified", "VMwareAccepted", or "PartnerSupported". The default is "PartnerSupported".
or
From a PowerCLI command prompt while connected to the ESXi host, run the following commands:
$esxcli = Get-EsxCli -v2
$arguments = $esxcli.software.acceptance.set.CreateArgs()
$arguments.level = "PartnerSupported"
$esxcli.software.acceptance.set.Invoke($arguments)
Note: "VMwareCertified" or "VMwareAccepted" may be substituted for "PartnerSupported", depending on local requirements. These are case sensitive.