OpenControls Logo

STIG Viewer

STIGViewer Support

The RUCKUS ICX multicast Designated Router (DR) must be configured to filter the Internet Group Management Protocol (IGMP) and Multicast Listener Discovery (MLD) Report messages to allow hosts to join only multicast groups that have been approved by the organization.

Overview

Finding IDVersionRule IDIA ControlsSeverity
V-273647RCKS-RTR-000800SV-273647r1111041_ruleCCI-002403low
Description
Real-time multicast traffic can entail multiple large flows of data. Large unicast flows tend to be fairly isolated (i.e., someone doing a file download here or there), whereas multicast can have broader impact on bandwidth consumption, resulting in extreme network congestion. Hence, it is imperative that there is multicast admission control to restrict which multicast groups hosts are allowed to join via IGMP or MLD.
STIGDate
RUCKUS ICX Router Security Technical Implementation Guide2025-06-03

Related Frameworks

1 mapping across 3 frameworks
SCF0 mappings

No source states a mapping between these directly.

Also reachable in 3 hops (2) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

NET-03Boundary Protection
0.50
NET-04.1Deny Traffic by Default & Allow Traffic by Exception
0.50
NIST 800-530 mappings

No source states a mapping between these directly.

Also reachable in 2 hops (8) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

CM-6Configuration Settings
1.00
SC-24Fail in Known State
1.00
SC-47Alternate Communications Paths
1.00
SC-5Denial-of-service Protection
1.00
SC-7Boundary Protection
1.00
SC-7(11)Restrict Incoming Communications Traffic
1.00
SC-7(29)Separate Subnets to Isolate Functions
1.00
SC-7(5)Deny by Default — Allow by Exception
1.00
CCI1 mapping
CCI-002403
1.00

Details

Check Text (C-273647r1111041_chk)

Review the configuration of the DR to verify it is filtering IGMP or MLD report messages, allowing hosts to only join multicast groups from sources that have been approved. Note: This requirement is only applicable to Source Specific Multicast (SSM) implementation. This requirement is not applicable to Any Source Multicast (ASM) since the filtering is being performed by the Rendezvous Pointerface router. 1. Verify all host facing interfaces are configured to filter IGMP Membership Report messages (IGMP joins) as shown in the example below: ICX(conf)#interface ethernet 1/2/1 ICX(config-if-e10000-1/2/1)#ip igmp ver 3 ICX(config-if-e10000-1/2/1)#ip igmp access-group IGMP_JOIN_FILTER ICX(config-ig-e1000-1/2/1)#show access-list all 2. Verify the output below (the access control list, or ACL) denies unauthorized groups or permits only authorized groups. The example below denies all groups from the 239.0.0.0/16 range. Standard IP access list IGMP_JOIN_FILTER: 2 entries 10: deny 239.0.0.0 0.0.255.255 20: permit any If the DR is not filtering IGMP or MLD report messages, this is a finding.

Fix Text (F-77643r1110775_fix)

Configure the DR to filter the IGMP and MLD report messages to allow hosts to join only those multicast groups from sources that have been approved. 1. Configure the Access Control List (ACL) to filter IGMP membership report messages as shown in the example below: ICX(config)#ip access-list standard IGMP_JOIN_FILTER ICX(config-std-ipacl-IGMP_JOIN_FILTER)#deny 239.0.0.0/16 ICX(config-std-ipacl-IGMP_JOIN_FILTER)#permit any ICX(config-std-ipacl-IGMP_JOIN_FILTER)#exit 2. Apply the filter to all nonhost-facing interfaces. ICX(config)interface ethernet 1/2/1 ICX(config-if-e1000-1/2/1)#ip igmp ver 3 ICX(config-if-e1000-1/2/1)#ip igmp access-group IGMP_JOIN_FILTER