The multicast Rendezvous Point (RP) must be configured to rate limit the number of Protocol Independent Multicast (PIM) Register messages.

Overview

Finding IDVersionRule IDIA ControlsSeverity
V-207160SRG-NET-000362-RTR-000121SV-207160r856644_ruleCCI-002385medium
Description
When a new source starts transmitting in a PIM Sparse Mode network, the DR will encapsulate the multicast packets into register messages and forward them to the RP using unicast. This process can be taxing on the CPU for both the DR and the RP if the source is running at a high data rate and there are many new sources starting at the same time. This scenario can potentially occur immediately after a network failover. The rate limit for the number of register messages should be set to a relatively low value based on the known number of multicast sources within the multicast domain.
STIGDate
Router Security Requirements Guide2025-09-10

Related Frameworks

6 paths across 3 frameworks
SCF4 mappings
CAP-01Capacity & Performance Management
0.50
  • DISA · V5R2 · disa_xccdf · related
  • DISA · 2025-01-23 · disa_cci_list · equivalent
  • Secure Controls Framework · 2026.2 · scf_strm · related
CAP-02Resource Priority
0.50
  • DISA · V5R2 · disa_xccdf · related
  • DISA · 2025-01-23 · disa_cci_list · equivalent
  • Secure Controls Framework · 2026.2 · scf_strm · related
CAP-03Capacity Planning
0.50
  • DISA · V5R2 · disa_xccdf · related
  • DISA · 2025-01-23 · disa_cci_list · equivalent
  • Secure Controls Framework · 2026.2 · scf_strm · related
NET-02.1Denial of Service (DoS) Protection
0.50
  • DISA · V5R2 · disa_xccdf · related
  • DISA · 2025-01-23 · disa_cci_list · equivalent
  • Secure Controls Framework · 2026.2 · scf_strm · related
NIST 800-531 mapping
SC-5
1.00
  • DISA · V5R2 · disa_xccdf · related
  • DISA · 2025-01-23 · disa_cci_list · equivalent
CCI1 mapping
CCI-002385
1.00
  • DISA · V5R2 · disa_xccdf · related

Details

Check Text (C-207160r856644_chk)

Review the configuration of the RP to verify that it is rate limiting the number of multicast register messages. If the RP is not limiting multicast register messages, this is a finding.

Fix Text (F-7421r382509_fix)

Configure the RP to rate limit the number of multicast register messages.