STIGViewer Support

YUM must remove all software components after updated versions have been installed on RHEL 8.

Overview

Finding IDVersionRule IDIA ControlsSeverity
V-230281RHEL-08-010440SV-230281r958936_ruleCCI-002617low
Description
Previous versions of software components that are not removed from the information system after updates have been installed may be exploited by adversaries. Some information technology products may remove older versions of software automatically from the information system.
STIGDate
Red Hat Enterprise Linux 8 Security Technical Implementation Guide2026-02-05

Related Frameworks

1 mapping across 3 frameworks
SCF0 mappings

No source states a mapping between these directly.

Also reachable in 3 hops (1) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

VPM-05.5Removal of Previous Versions
1.00
NIST 800-530 mappings

No source states a mapping between these directly.

Also reachable in 2 hops (1) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

SI-2(6)Removal of Previous Versions of Software and Firmware
1.00
CCI1 mapping

Details

Check Text (C-230281r958936_chk)

Verify the operating system removes all software components after updated versions have been installed. Check if YUM is configured to remove unneeded packages with the following command: $ sudo grep -i clean_requirements_on_remove /etc/dnf/dnf.conf clean_requirements_on_remove=True If "clean_requirements_on_remove" is not set to either "1", "True", or "yes", commented out, or is missing from "/etc/dnf/dnf.conf", this is a finding.

Fix Text (F-32925r567590_fix)

Configure the operating system to remove all software components after updated versions have been installed. Set the "clean_requirements_on_remove" option to "True" in the "/etc/dnf/dnf.conf" file: clean_requirements_on_remove=True