STIGViewer Support

RHEL 10 must enable FIPS mode.

Overview

Finding IDVersionRule IDIA ControlsSeverity
V-281009RHEL-10-000500SV-281009r1184724_ruleCCI-000068high
Description
Use of weak or untested encryption algorithms undermines the purposes of using encryption to protect data. The operating system must implement cryptographic modules adhering to the higher standards approved by the federal government because this provides assurance they have been tested and validated. Satisfies: SRG-OS-000033-GPOS-00014, SRG-OS-000125-GPOS-00065, SRG-OS-000250-GPOS-00093, SRG-OS-000393-GPOS-00173, SRG-OS-000394-GPOS-00174, SRG-OS-000396-GPOS-00176, SRG-OS-000423-GPOS-00187, SRG-OS-000478-GPOS-00223
STIGDate
Red Hat Enterprise Linux 10 Security Technical Implementation Guide2026-03-11

Related Frameworks

1 mapping across 4 frameworks
SCF0 mappings

No source states a mapping between these directly.

Also reachable in 3 hops (1) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

NET-14.2Protection of Confidentiality / Integrity Using Encryption
1.00
NIST 800-530 mappings

No source states a mapping between these directly.

Also reachable in 2 hops (33) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

AC-17(1)Monitoring and Control
1.00
AC-17(2)Protection of Confidentiality and Integrity Using Encryption
1.00
AC-3Access Enforcement
1.00
CM-6Configuration Settings
1.00
CM-6(1)Automated Management, Application, and Verification
1.00
CM-7Least Functionality
1.00
CM-7(1)Periodic Review
1.00
IA-2(8)Access to Accounts — Replay Resistant
1.00
IA-2(9)Network Access to Non-privileged Accounts — Replay Resistant
1.00
IA-3Device Identification and Authentication
1.00

+23 more (top 10 by confidence shown)

NIST 800-1710 mappings

No source states a mapping between these directly.

Also reachable in 3 hops (1) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

3.1.13
1.00
CCI1 mapping

Details

Check Text (C-281009r1184724_chk)

Verify RHEL 10 is in FIPS mode with the following command: $ cat /proc/sys/crypto/fips_enabled 1 If the command does not return "1", this is a finding.

Fix Text (F-85475r1184723_fix)

Configure RHEL 10 to implement FIPS mode. If this check fails on an installed system, it is a permanent finding until the system is reinstalled with "fips=1" during installation. Red Hat 10 does not support switching to strict FIPS mode after installation.