Refer to IEASYS00 member in SYS1.PARMLIB Concatenation. Determine proper SMFPRMxx member. Examine the JWT, SWT, and TWT values. If the JWT parameter is greater than "15" minutes, and the system is processing unclassified information, review the following items. If any of these items is true, this is not a finding. -If a session is not terminated, but instead is locked out after 15 minutes of inactivity, a process must be in place that requires user identification and authentication before the session is unlocked. Session lock-out will be implemented through system controls or terminal screen protections. -A system's default time for terminal lock-out or session termination may be lengthened to 30 minutes at the discretion of the ISSM or ISSO. The ISSM and/or ISSO will maintain the documentation for each system with a time-out adjusted beyond the 15-minute recommendation to explain the basis for this decision. -The ISSM and/or ISSO may set selected userids to have a time-out of up to 60 minutes in order to complete critical reports or transactions without timing out. Each exception must meet the following criteria: -The time-out exception cannot exceed 60 minutes. -A letter of justification fully documenting the user requirement(s) must be submitted and approved by the site ISSM or ISSO. In addition, this letter must identify an alternate means of access control for the terminal(s) involved (e.g., a room that is locked at all times, a room with a cipher lock to limit access, a password protected screen saver set to 30 minutes or less, etc.). -The requirement must be revalidated on an annual basis. If the TWT and SWT values are equal or less than the JWT value, this is not a finding.