If DOD is not at C2C Step 3 or higher, this is not a finding. Use the Forescout Administrator UI to verify that policies are configured to filter the policy assessment devices based on risk and are remediated or isolated according to the SSP. 1. In the Forescout UI, go to the Policy Tab >> Compliance or Control Policies. 2. Verify the action within Compliance Policies is configured with one of the following actions: - Terminate the connection and place the device on a denylist to prevent future connection attempts until action is taken to remove the device from the denylist. - Redirect traffic from the remote endpoint to the automated remediation subnet for connection to the remediation server or segment the endpoint to a remediation VLAN. Use of ACLs or a VLAN solution is acceptable. - Allow the device access to limited network services such as public web servers in the protected DMZ (must be approved by the authorizing official [AO]). - Allow the device and user full entry into the protected networks, but flag it for future remediation. With this option, an automated reminder should be used to inform the user of the remediation status. If Forescout does not communicate with the remote access gateway to implement a policy to either terminate the session or isolate the device from the trusted network this is a finding.