STIGViewer Support

The firewall must deny network communications traffic by default and allow network communications traffic by exception (i.e., deny all, permit by exception).

Overview

Finding IDVersionRule IDIA ControlsSeverity
V-206694SRG-NET-000202-FW-000039SV-206694r604133_ruleCCI-001109high
Description
To prevent malicious or accidental leakage of traffic, organizations must implement a deny-by-default security posture at the network perimeter. Such rulesets prevent many malicious exploits or accidental leakage by restricting the traffic to only known sources and only those ports, protocols, or services that are permitted and operationally necessary. As a managed boundary interface, the firewall must block all inbound and outbound network traffic unless a filter is installed to explicitly allow it. The allow filters must comply with the Ports, Protocols, and Services Management (PPSM) Category Assurance List (CAL) and Vulnerability Assessment (VA).
STIGDate
Firewall Security Requirements Guide2024-12-04

Related Frameworks

1 mapping across 4 frameworks
SCF0 mappings

No source states a mapping between these directly.

Also reachable in 3 hops (1) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

NET-04.1Deny Traffic by Default & Allow Traffic by Exception
0.50
NIST 800-530 mappings

No source states a mapping between these directly.

Also reachable in 2 hops (6) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

AC-4Information Flow Enforcement
1.00
SC-24Fail in Known State
1.00
SC-5Denial-of-service Protection
1.00
SC-7Boundary Protection
1.00
SC-7(11)Restrict Incoming Communications Traffic
1.00
SC-7(5)Deny by Default — Allow by Exception
1.00
NIST 800-1710 mappings

No source states a mapping between these directly.

Also reachable in 3 hops (1) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

3.13.6
1.00
CCI1 mapping

Details

Check Text (C-206694r604133_chk)

Determine the default security policies on the firewall for traffic from one zone to another zone (inter-zone). The default policy must be a "Deny" policy that blocks all inter-zone traffic by default. Ensure no policy that circumvents the default "Deny" inter-zone policy is allowed. Traffic through the firewall is filtered so that only the specific traffic that is approved and registered in the PPSM CAL and VAs for the enclave. Verify rules or access control statements containing "any" for either the host, destination, protocol, or port are not used. If the firewall does not deny all network communications traffic by default and allow network communications traffic by exception (i.e., deny all, permit by exception), this is a finding.

Fix Text (F-6951r297862_fix)

Configure the firewall with a "Deny" inter-zone policy which, by default, blocks traffic between zones and allows network communications traffic by exception (i.e., deny all, permit by exception) in accordance with PPSM CAL and VAs for the enclave.