OpenControls Logo

STIG Viewer

STIGViewer Support

The Cisco BGP switch must be configured to use its loopback address as the source address for iBGP peering sessions.

Overview

Finding IDVersionRule IDIA ControlsSeverity
V-221112CISC-RT-000580SV-221112r999769_ruleCCI-004931low
Description
Using a loopback address as the source address offers a multitude of uses for security, access, management, and scalability of the BGP switches. It is easier to construct appropriate ingress filters for switch management plane traffic destined to the network management subnet since the source addresses will be from the range used for loopback interfaces instead of a larger range of addresses used for physical interfaces. Log information recorded by authentication and syslog servers will record the switch’s loopback address instead of the numerous physical interface addresses. When the loopback address is used as the source for eBGP peering, the BGP session will be harder to hijack since the source address to be used is not known globally, making it more difficult for a hacker to spoof an eBGP neighbor. By using traceroute, a hacker can easily determine the addresses for an eBGP speaker when the IP address of an external interface is used as the source address. The switches within the iBGP domain should also use loopback addresses as the source address when establishing BGP sessions.
STIGDate
Cisco NX OS Switch RTR Security Technical Implementation Guide2026-03-04

Related Frameworks

1 mapping across 3 frameworks
SCF0 mappings

No source states a mapping between these directly.

Also reachable in 3 hops (1) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

BCD-10.4Alternate Communications Channels
1.00
NIST 800-530 mappings

No source states a mapping between these directly.

Also reachable in 2 hops (5) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

SC-47Alternate Communications Paths
1.00
SC-5(2)Capacity, Bandwidth, and Redundancy
1.00
SC-7Boundary Protection
1.00
SC-7(11)Restrict Incoming Communications Traffic
1.00
SC-7(29)Separate Subnets to Isolate Functions
1.00
CCI1 mapping
CCI-004931
1.00

Details

Check Text (C-221112r999769_chk)

Step 1: Review the switch configuration to verify that a loopback address has been configured. interface loopback0 ip address 10.1.1.1/32 Step 2: Verify that the loopback interface is used as the source address for all iBGP sessions. router bgp xx router-id 10.1.1.1 address-family ipv4 unicast neighbor 10.1.12.2 remote-as xx password 3 7b07d1b3023056a9 update-source loopback0 If the switch does not use its loopback address as the source address for all iBGP sessions, this is a finding.

Fix Text (F-22816r409826_fix)

Configure the switch to use its loopback address as the source address for all iBGP peering. SW1(config)# router bgp xx SW1(config-router)# neighbor 10.1.12.2 SW1(config-router-neighbor)# update-source lo0 SW1(config-router-neighbor)# end