OpenControls Logo

STIG Viewer

STIGViewer Support

The Cisco perimeter switch must be configured to have Cisco Discovery Protocol (CDP) disabled on all external interfaces.

Overview

Finding IDVersionRule IDIA ControlsSeverity
V-221017CISC-RT-000370SV-221017r856412_ruleCCI-002403low
Description
CDP is a Cisco proprietary neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. CDP is media-and-protocol-independent as it runs over layer 2; therefore, two network nodes that support different layer 3 protocols can still learn about each other. Allowing CDP messages to reach external network nodes provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack.
STIGDate
Cisco IOS XE Switch RTR Security Technical Implementation Guide2026-03-04

Related Frameworks

1 mapping across 3 frameworks
SCF0 mappings

No source states a mapping between these directly.

Also reachable in 3 hops (2) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

NET-03Boundary Protection
0.50
NET-04.1Deny Traffic by Default & Allow Traffic by Exception
0.50
NIST 800-530 mappings

No source states a mapping between these directly.

Also reachable in 2 hops (8) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

CM-6Configuration Settings
1.00
SC-24Fail in Known State
1.00
SC-47Alternate Communications Paths
1.00
SC-5Denial-of-service Protection
1.00
SC-7Boundary Protection
1.00
SC-7(11)Restrict Incoming Communications Traffic
1.00
SC-7(29)Separate Subnets to Isolate Functions
1.00
SC-7(5)Deny by Default — Allow by Exception
1.00
CCI1 mapping
CCI-002403
1.00

Details

Check Text (C-221017r856412_chk)

Step 1: Verify if CDP is enabled globally as shown below: cdp run By default, CDP is not enabled globally or on any interface. If CDP is enabled globally, proceed to Step 2. Step 2: Verify CDP is not enabled on any external interface as shown in the example below: interface GigabitEthernet2 ip address z.1.24.4 255.255.255.252 … … … cdp enable If CDP is enabled on any external interface, this is a finding.

Fix Text (F-22721r408846_fix)

Disable CDP on all external interfaces via no cdp enable command or disable CDP globally via no cdp run command.