The Cisco switch must be configured to have all inactive layer 3 interfaces disabled.
Overview
| Finding ID | Version | Rule ID | IA Controls | Severity |
| V-220991 | CISC-RT-000060 | SV-220991r622190_rule | CCI-001414 | low |
| Description | ||||
| An inactive interface is rarely monitored or controlled and may expose a network to an undetected attack on that interface. Unauthorized personnel with access to the communication facility could gain access to a switch by connecting to a configured interface that is not in use. If an interface is no longer used, the configuration must be deleted and the interface disabled. For sub-interfaces, delete sub-interfaces that are on inactive interfaces and delete sub-interfaces that are themselves inactive. If the sub-interface is no longer necessary for authorized communications, it must be deleted. | ||||
| STIG | Date | |||
| Cisco IOS XE Switch RTR Security Technical Implementation Guide | 2025-05-20 | |||
Details
Check Text (C-220991r622190_chk)
Review the switch configuration and verify that inactive interfaces have been disabled as shown below:
interface GigabitEthernet3
no switchport
shutdown
!
interface GigabitEthernet4
no switchport
shutdown
If an interface is not being used but is configured or enabled, this is a finding.
Fix Text (F-22695r408768_fix)
Disable all inactive interfaces as shown below:
SW1(config)#interface GigabitEthernet3
SW1(config-if)#shutdown
SW1(config)#interface GigabitEthernet4
SW1(config-if)#shutdown