The Cisco multicast Rendezvous Point (RP) router must be configured to filter Protocol Independent Multicast (PIM) Join messages received from the Designated Router (DR) for any undesirable multicast groups.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-216627	CISC-RT-000840	SV-216627r531085_rule	CCI-001414	low
Description
Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast packets, over-using the available bandwidth and thereby creating a denial-of-service (DoS) condition. Hence, it is imperative that join messages are only accepted for authorized multicast groups.
STIG			Date
Cisco IOS Router RTR Security Technical Implementation Guide			2024-11-25

Details

Check Text (C-216627r531085_chk)

Verify that the RP router is configured to filter PIM join messages for any undesirable multicast groups. In the example below, groups from 239.8.0.0/16 are not allowed. ip pim rp-address 10.2.2.2 ip pim accept-rp 10.2.2.2 FILTER_PIM_JOINS … … … ip access-list standard FILTER_PIM_JOINS deny 239.8.0.0 0.0.255.255 permit any ! If the RP is not configured to filter join messages received from the DR for any undesirable multicast groups, this is a finding.

Fix Text (F-17858r287251_fix)

Configure the RP to filter PIM join messages for any undesirable multicast groups as shown in the example below. R2(config)#ip access-list standard PIM_JOIN_FILTER R2(config-std-nacl)#deny 239.8.0.0 0.0.255.255 R2(config-std-nacl)#permit any R2(config-std-nacl)#exit R2(config)#ip pim accept-rp 10.2.2.2 PIM_JOIN_FILTER R2(config)#end