OpenControls Logo

STIG Viewer

STIGViewer Support

The Cisco ACI multicast must be configured to filter the Internet Group Management Protocol (IGMP) and Multicast Listener Discovery (MLD) Report messages to allow hosts to join only multicast groups and only from sources that have been approved by the organization.

Overview

Finding IDVersionRule IDIA ControlsSeverity
V-272095CACI-RT-000035SV-272095r1168413_ruleCCI-002403low
Description
Real-time multicast traffic can entail multiple large flows of data. Large unicast flows tend to be fairly isolated (i.e., occasional file downloads), whereas multicast can have broader impact on bandwidth consumption, resulting in extreme network congestion. Hence, it is imperative that there is multicast admission control to restrict which multicast groups hosts are allowed to join via IGMP or MLD. Satisfies: SRG-NET-000364-RTR-000115
STIGDate
Cisco ACI Router Security Technical Implementation Guide2025-12-11

Related Frameworks

1 mapping across 3 frameworks
SCF0 mappings

No source states a mapping between these directly.

Also reachable in 3 hops (2) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

NET-03Boundary Protection
0.50
NET-04.1Deny Traffic by Default & Allow Traffic by Exception
0.50
NIST 800-530 mappings

No source states a mapping between these directly.

Also reachable in 2 hops (8) derived by us, not asserted by any source

Each of these is a route we composed by chaining published mappings. No publisher states a relationship between the two endpoints.

CM-6Configuration Settings
1.00
SC-24Fail in Known State
1.00
SC-47Alternate Communications Paths
1.00
SC-5Denial-of-service Protection
1.00
SC-7Boundary Protection
1.00
SC-7(11)Restrict Incoming Communications Traffic
1.00
SC-7(29)Separate Subnets to Isolate Functions
1.00
SC-7(5)Deny by Default — Allow by Exception
1.00
CCI1 mapping
CCI-002403
1.00

Details

Check Text (C-272095r1168413_chk)

This requirement is only applicable to Source Specific Multicast (SSM) implementation. This requirement is not applicable to Any Source Multicast (ASM), since the filtering is being performed by the rendezvous point switch. Review the configuration to verify filtering IGMP or MLD Membership Report messages, allowing hosts to join only those groups that have been approved. Navigate to the following location to review the settings: Tenants >> {{your_Tenant}} >> Networking >> Bridge Domain >> {{your_Bridge_Domain}} >> Policy >> General If the Cisco ACI is not filtering IGMP or MLD Membership Report messages, this is a finding.

Fix Text (F-76052r1168171_fix)

Configure IGMP Snooping. Note: There are a number of methods for meeting this requirement; however, it is recommended to use filter Destinations via contracts and PIM destination filter route maps when enabling the Bridge domain to participate in IGMP and MLD Snooping. All but the contract settings can be found at the following GUI path: Tenants >> {{your_Tenant}} >> Networking >> Bridge Domain >> {{your_Bridge_Domain}} >> Policy >> General