RHEL 9 must not send Internet Control Message Protocol (ICMP) redirects.

Overview

Finding ID	Version	Rule ID	IA Controls	Severity
V-257968	RHEL-09-253065	SV-257968r942997_rule		Medium

Description
ICMP redirect messages are used by routers to inform hosts that a more direct route exists for a particular destination. These messages contain information from the system's route table possibly revealing portions of the network topology. The ability to send ICMP redirects is only appropriate for systems acting as routers.

STIG	Date
Red Hat Enterprise Linux 9 Security Technical Implementation Guide	2023-12-01

Details

Check Text ( C-61709r942996_chk )

Verify RHEL 9 does not IPv4 ICMP redirect messages. Check the value of the "all send_redirects" variables with the following command: $ sudo sysctl net.ipv4.conf.all.send_redirects net.ipv4.conf.all.send_redirects = 0 If the returned line does not have a value of "0", or a line is not returned, this is a finding. Check that the configuration files are present to enable this network parameter. $ sudo /usr/lib/systemd/systemd-sysctl --cat-config | egrep -v '^(#|;)' | grep -F net.ipv4.conf.all.send_redirects | tail -1 net.ipv4.conf.all.send_redirects = 0 If "net.ipv4.conf.all.send_redirects" is not set to "0" and is not documented with the information system security officer (ISSO) as an operational requirement or is missing, this is a finding.

Fix Text (F-61633r925890_fix)
Configure RHEL 9 to not allow interfaces to perform IPv4 ICMP redirects. Add or edit the following line in a single system configuration file, in the "/etc/sysctl.d/" directory: net.ipv4.conf.all.send_redirects = 0 Load settings from all system configuration files with the following command: $ sudo sysctl --system